CZ Accessoires

Huma-Air CZ 200 Tuning Regulator

Huma-Air CZ 200 Tuning Regulator
This regulator is specially made to fit the Air Arms S200 airrifle, or the CZ200 model with quickfill
The Huma regulator will regulate the airpressure in your S200/CZ200 airgun. It reduces the primary high fill pressure in the cylinder into a lower pre-set working pressure. This will give you a constant pelletspeed and a higher accuracy.
The design volume is based on the 16 Joule version but it can be set higher, if preffered.

The installation of the regulator is very simple. The regulator is placed inside the pressure tube of the rifle and you are ready.
It is vented to the atmosphere, without the need of a breath hole in the cylinder, so no creeping up in power during time,

The benefits

• Higher accuracy of your rifle due to the elimination of the pelletspeed fluctuations
• A constant pellet speed over the full working pressure range.
• It will give you a better shotcount and a full flat shotstring immediately.
• Adding a regulator to your airrifle will probably give you the biggest benefit in the tuning process.
• Often the rifle will make less noise due to better balance in air usage.

Pressure settings
The regulator comes preset at the most common pressure setting, or we will adjust it according to your personal wishes. The pressure range is adjustable from 70-150 bar. It is also equipped with a clear pressure scale label, so you can very easy re-adjust or fine tune the pressure setting suitable to your wishes. After fitting the regulator, always check the powersetting of the rifle and finetune it when needed to stay within legal limits.

Quality
The regulator is CNC produced out of high grade aircraft Aluminum and bronze.
To guarantee a perfect product, every regulator is manually assembled, tested and adjusted to the requested pressure. 
We only use belleville springs designed for critical applications to achieve the highest repeat accuracy. This gives our regulators a repeat cycle less than 1% difference.

* Gelieve hieronder aan te geven voor welk kalilber u de regulator wilt bestellen en welke setting u wilt. Als u een custom setting wilt geef dit dan aan in het opmerkingen veld. U komt dit veld vanzelf tegen als u verder gaat met bestellen.

Huma-Air regulator tester (Air Arms, BSA en CZ)

This regulator tester device  is specially designed to test and service our Huma-Air regulators for BSA,  Air Arms S200 and CZ200.  With this model you can test the Huma-Air models below:

• Air Arms S200 external regulator
• Air Arms S200 internal regulator
• BSA Scorpion external regulator
• BSA Ultra MMC external regulator
• BSA Ultra SE regulator
• BSA Scorpion SE regulator
• BSA Internal regulator
• CZ200 external regulator
• CZ200 internal regulator

Check the proper working and cycling, adjust the regulator after a full rebuild or just experiment to find out the best pressure setting of your rifle.
The tester is suitable for a wide range of Huma-Air regulators (see list above) and has a easy to use depressurize screw. It has a large 63 mm oil filled pressure gauge with clear scale in PSI and Bar.
After depresurizing your rifle totally, you can unscrew the pressure tube + regulator from the valve body of the rifle and screw the regulator tester directly into the pressure tube. Then you can presurize your pressure tube again and check the regulator output pressure, the regulator cylce etc by simulating shots by using the de-presurize screw. The input pressure is suitable for 232 bar.

For high durability we have used a combination of anodizided aircraft aluminum for the body and a bronze depresurize screw.

Magazijn CZ model 200 10 schots 4.5 mm

Magazijn CZ model 200 10 schots. 

4.5 mm